This article supports manual programming functions for the 600, 700, 800, 4500, 5500, 6500 series of commercial WiFi locks. While the easiest way to manage and program your locks is through the SimpleAccess software portal, many functions can also be programmed in manually.
Several settings and functions can be programmed via the locks keypad. For locks connected to WiFi, many of the functions are performed via the portal. If you desire to use the locks only in Offline Mode (not connected via WiFi or to the portal), manual programming is required to utilize features of the lock.
Programming functions start by entering the Programming Code, which is like a password for your lock. All programming via the keypad follows a specific pattern:
- Enter your Programming Code, followed by the # button
- Enter the Function Code for the desired function, followed by the # button
- Some functions also require a Function Value, followed by the # button
Examples
100: Change Programming Code
The programming code is like a password. By default it is set to 123456. You will want to change this right away to secure your lock. To change your Programing Code, enter the following on the keypad:
123456 (default PC), #, 100, #, [4-10 digit new PC], #
If successful, you will see two green flashes and hear two peeps. If an error was made, you will see a red flash.
110: Add a Local User Code
Local User Codes are intended to be used as a backup to User Codes created from the app, or for long term users for Offline Mode Locks. These User Codes can be 4-8 digits in length and up to 100 can be stored on the lock.
To add new Local User PIN, enter;
PC, #, 110, #, [PIN Code], #
Note: Single digit pins (1111, 2222) and sequential pins (1234, 3456) are not allowed for security reasons.
128: Block ReadyPIN
If you have issued a ReadyPIN and now need to revoke access, this can be done by "blocking" a specific ReadyPIN. To block a ReadyPIN, enter;
PC, #, 1128, #, [ReadyPIN], #
Additional Function Codes
100 New Programming Code | 4-10 chars | Default = 123456
110 Add Local Code | 4-10 chars | Default 1234 or 4321
112 Add Local Card | after 112, scan card within 8 seconds - only 1 card per
120 Delete Local Code (enter PIN to be deleted)
122 Delete Smart Cards (hold card to delete to lock)
128 Block individual ReadyPIN
129 Clear all blocked ReadyPINs
130 Erase all Local Codes including default code
133 Erase all access codes | web, keypad & default
135 Factory reset
155 Set consecutive failed codes before lockout |Default = 5
156 Sets number of seconds to lockout keypad |Default = 60, 0 to disable
160 Mute On
161 Mute Off
198 Set Time | YYMMDDhhmm format
270 Auto Lock Mode OFF
271 Auto Lock Mode ON | Default
260 Set Auto Lock Timer | 5 – 1,800 Seconds | Default = 5 Seconds
310 Reset WiFi Connection
311 Reset/Reboot WiFi Module
312 Reset/Erase SSID’s
320 Enter AP Mode (if adding second SSID)
360 Turn off wifi
361 Turn on wifi
370 Turn off algorithmic codes
371 Turn on algorithmic codes
380 Turn off NFC (Card reader)
381 Turn on NFC with motion sensor to read cards
382 Turn on NFC with keypress to read cards
390 Require # pound on keypad after PIN entry
391 Auto-Enter | Default: no # key needed
411 Wake WiFi for single connect (even if WiFi turned off)
420 Disable Card Serial Number as PIN | Default
421 Enable Card Serial Number as PIN
500 Soft Reboot